Home›Knowledge›Lockout/Tagout (OSHA 1910.147/1926.417)
⛑️ Safetyconstruction

Lockout/Tagout (OSHA 1910.147/1926.417)

Updated Mar 26, 2026
Energy control procedures for construction equipment and electrical systems. Covers lockout devices, tagout procedures, group lockout, periodic inspections, and contractor coordination for servicing equipment with stored or potential energy.
TAGS
OSHAlockouttagoutenergy-controlelectrical
DETAILS
section
1910.147 / 1926.417
category
LOTO
jurisdiction
us
regulation body
OSHA
RELATED KNOWLEDGE
⛑️ Safety
OSHA 1926.501 — Fall Protection Duty to Have Fall Protection
Each employee on a walking/working surface with an unprotected side or edge 6 feet or more above a lower level shall be protected from falling by guardrail, safety net, or personal fall arrest system.
⛑️ Safety
OSHA 1926.651 — Excavation General Requirements
Excavations deeper than 5 feet require protective systems (sloping, shoring, or shielding) unless excavation is made entirely in stable rock. All excavations 20 feet or deeper require engineering design.
📋 Code
IBC Section 1107 — Accessible Unit and Dwelling Unit Elements
Requires accessible common use elements within individual residential units.
⛑️ Safety
OSHA 1926.1200-1213 — Confined Space Entry in Construction
Permit-required confined space entry requires atmosphere testing, ventilation, trained attendant, rescue plan, and written permit. Applies to manholes, tanks, vaults, pits, and excavations over 4 feet deep.
⛑️ Safety
OSHA 1926.1053 — Ladders
Requirements for portable and fixed ladders. Extend 3 feet above landing. 4:1 pitch ratio for portable. Load capacity rated. Inspect before each use. #3 cause of fall injuries in construction.
⛑️ Safety
OSHA 1926.451 — Scaffolding General Requirements
Scaffolds must support 4x intended load without failure. Guardrails required at 10 feet. Competent person must supervise erection. Workers must be trained. #2 most-cited OSHA standard in construction.
← Back to Knowledge Garden